[nels0n]

Hi,

I'm simulating a flow over a flood evacuator in Flow 3D v11.1 and I get the following message:

Preprocessor Messages:
*****************************************
warning
irating(2) for block # 1 is reset to 0
*****************************************

Does someone know why this message is appearing and how can I fix this?
Thanks

[user01]

Originally Posted by nels0n

Hi,

I'm simulating a flow over a flood evacuator in Flow 3D v11.1 and I get the following message:

Preprocessor Messages:
*****************************************
warning
irating(2) for block # 1 is reset to 0
*****************************************

Does someone know why this message is appearing and how can I fix this?
Thanks

Hi!

Have you activated any event? I suppose that you are using fluid elevation, is correct?

irating = 0 means that fluid elevation vs. time is user-prescribed.

Regards.