FLSGRF file open ERROR

beck · June 8, 2015, 05:26

Hallo everybody,

i try to use a tracer in a restart simulation. The base simulation for the restart runs without difficulties but now i get the same error, everytime i start the simulation. I didn´t find anything about the problem...the warning message reads as follows:

FLSGRF file open ERROR file name = ...

unit = 15
record length = 0
I/O error = 30

The simulation starts and runs without problems but after a few seconds (different timesteps), it quits..

Thank you.

meena · November 26, 2022, 03:12

hi,
did you find the solution to this?

shaun13 · January 25, 2023, 13:30

and I don't even know why this problem happens, not mention to the solution

geometry dash

June 8, 2015, 05:26	FLSGRF file open ERROR	#1
beck New Member tarek Join Date: Nov 2012 Posts: 2 Rep Power: 0	Hallo everybody, i try to use a tracer in a restart simulation. The base simulation for the restart runs without difficulties but now i get the same error, everytime i start the simulation. I didn´t find anything about the problem...the warning message reads as follows: FLSGRF file open ERROR file name = ... unit = 15 record length = 0 I/O error = 30 The simulation starts and runs without problems but after a few seconds (different timesteps), it quits.. Thank you.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Building OpenFOAM1.7.0 from source	ata	OpenFOAM Installation	46	March 6, 2022 14:21
what is swap4foam ??	AB08	OpenFOAM	28	February 2, 2016 02:22
centOS 5.6 : paraFoam not working	yossi	OpenFOAM Installation	2	October 9, 2013 02:41
friction forces icoFoam	ofslcm	OpenFOAM	3	April 7, 2012 11:57
user subroutine error	CFDUSER	CFX	2	December 9, 2006 07:31

November 26, 2022, 03:12		#2
meena New Member Delhi Join Date: Nov 2019 Posts: 3 Rep Power: 7	hi, did you find the solution to this?

January 25, 2023, 13:30		#3
shaun13 New Member shaun Join Date: Jan 2023 Posts: 1 Rep Power: 0	and I don't even know why this problem happens, not mention to the solution geometry dash