 |
 |
 |
|
|
|
[Sponsors] | ||||
January 10, 2014, 02:14
|
Early finish time
|
#1 |
|
New Member
Join Date: Jan 2014
Posts: 5
Rep Power: 12  |
Hello
I am quite new in using flow-3D simulation software. I am runing a simulation that should simulate a 120 s long interaction between hot gases and water in sertain geometry. However the simulations ends after 6 - 8 seconds. Is there a reseon for that or did it crashed? Thank you for your reply (sorry for my english) |
|
|
|
|
|
January 11, 2014, 01:04
|
|
#2 |
|
New Member
Mohammadreza
Join Date: Nov 2013
Posts: 11
Rep Power: 13 |
Dear Paulius
What is your stop criteria? Most of the time this problems is due to set incorrect stop criteria! However I am Flow-3D CAST user and don't hesitate if you have any question! this is my e-mail address: mo.sharifabadi@gmail.com if you want contact with me. Regards, M. R. Sharifabadi |
|
|
|
|
|
 |
| Tags |
| crashing, simulation time |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rapidly decreasing deltaT for interDyMFoam | chrisb2244 | OpenFOAM Running, Solving & CFD | 3 | July 1, 2014 17:40 |
| InterFoam negative alpha | karasa03 | OpenFOAM | 7 | December 12, 2013 04:41 |
| pisoFoam with k-epsilon turb blows up - Some questions | Heroic | OpenFOAM Running, Solving & CFD | 26 | December 17, 2012 04:34 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 05:03 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 06:24 |
Linear Mode
