void region problem

ljx151126 · December 12, 2013, 22:34

Hi,everyone. When I run a sediment scour model, the solver stopped abnormaly. The warning and error messages are: void region problem, surface cell with no adjacent void at i=85, j=60, k=28. I want to know how to solver this problem. Thank you very much.

JBurnham · December 15, 2013, 22:07

That's an old bug that has been fixed in 10.1.1, the latest version. I ran into that problem too. - J

ljx151126 · December 15, 2013, 22:27

Dear Jeff Burnham
I really appreciate your help. I use the version 10.0.1 to do simulation. So I cann't continue my sediment scour model?
Thanks greatly.

JBurnham · December 18, 2013, 21:32

You can try using a different mesh configuration, but otherwise, you'll need to update the software: there's a menu at the top (Utilities > Auto-update) that will let you get a later version, but you'll need a username and password from Flow Science.

December 12, 2013, 22:34	void region problem	#1
ljx151126 New Member jinxing liu Join Date: Dec 2013 Posts: 2 Rep Power: 0	Hi,everyone. When I run a sediment scour model, the solver stopped abnormaly. The warning and error messages are: void region problem, surface cell with no adjacent void at i=85, j=60, k=28. I want to know how to solver this problem. Thank you very much.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] engineFoam new mesh problem	ayhan515	OpenFOAM Meshing & Mesh Conversion	5	August 10, 2015 09:45
[Gmsh] Import problem	ARC	OpenFOAM Meshing & Mesh Conversion	0	February 27, 2010 11:56
void region and itb=0	ehsan	FLOW-3D	2	January 26, 2009 12:53
OpenFoam 14 installation problem	gfcoppola	OpenFOAM Installation	20	November 2, 2007 14:38
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 05:15

December 15, 2013, 22:07		#2
JBurnham Senior Member Jeff Burnham Join Date: Apr 2010 Posts: 204 Rep Power: 17	That's an old bug that has been fixed in 10.1.1, the latest version. I ran into that problem too. - J

December 15, 2013, 22:27		#3
ljx151126 New Member jinxing liu Join Date: Dec 2013 Posts: 2 Rep Power: 0	Dear Jeff Burnham I really appreciate your help. I use the version 10.0.1 to do simulation. So I cann't continue my sediment scour model? Thanks greatly.

December 18, 2013, 21:32		#4
JBurnham Senior Member Jeff Burnham Join Date: Apr 2010 Posts: 204 Rep Power: 17	You can try using a different mesh configuration, but otherwise, you'll need to update the software: there's a menu at the top (Utilities > Auto-update) that will let you get a later version, but you'll need a username and password from Flow Science.