 |
 |
 |
|
|
|
[Sponsors] | ||||
November 9, 2013, 16:47
|
mass source
|
#1 |
|
New Member
razieh anari
Join Date: May 2013
Posts: 6
Rep Power: 13  |
I have a question about the " Mass source " in flow 3d.
I want to simulation a tube with a steady flow. the stream entered the vertical pipe & fill the whole pipe section at top . I created the mass source top of the vertical pipe, that the center of mass is on the center of pipe, & the direction is -z . the mass source is circular and its radius is equal to pipe radius. but the problem is: after simulation , i saw the mass source filled the half pipe section. I don't know why? please advise me .Thank you very much. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GPU Linear Solvers for OpenFOAM | gocarts | OpenFOAM Announcements from Other Sources | 37 | August 17, 2022 15:22 |
| [swak4Foam] groovyBC in openFOAM-2.0 for parabolic velocity bc | ofslcm | OpenFOAM Community Contributions | 25 | March 6, 2017 11:03 |
| [swak4Foam] funkySetFields compilation error | tayo | OpenFOAM Community Contributions | 39 | December 3, 2012 06:18 |
| Problem with Mass source, Momentum source theory | diffo | Fluent UDF and Scheme Programming | 0 | August 20, 2009 07:10 |
| OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 20:08 |
Linear Mode
