Probe Point List on v10.

madzero · August 15, 2012, 10:11

Hi! I'm new using Flow-3D v10, in the example:

Casting Tutorial - Sand Casting Filling Simulation: Create the Mesh.
Measure the Geometry to Determine a Good Cell Size.

In the fourth paragraph reads: "Hold CTRL, place the target-cursor exactly on the edge of a runner, and left-click to add x,y,z values to the table. Zoom in to get the most accurate values. Repeat for the opposite side of a runner, and subtract in the direction measured to find the width."

I do that the instructions say, but the test points don't appear.

Any help please? Thanks!

dmilano · August 15, 2012, 15:00

This is a typo in the manual. use shift+click instead.

madzero · August 15, 2012, 15:48

Well, initially when I used shift+left-click, didn't show any value in the table of probe points, but after almost press every key of keyboard+left-click and note that there appeared no value, I used again shift+left-click and new values appears in the table of probe points.

Thanks for the help!

August 15, 2012, 10:11	Probe Point List on v10.	#1
madzero New Member M4dZ3r0 Join Date: Aug 2012 Posts: 2 Rep Power: 0	Hi! I'm new using Flow-3D v10, in the example: Casting Tutorial - Sand Casting Filling Simulation: Create the Mesh. Measure the Geometry to Determine a Good Cell Size. In the fourth paragraph reads: "Hold CTRL, place the target-cursor exactly on the edge of a runner, and left-click to add x,y,z values to the table. Zoom in to get the most accurate values. Repeat for the opposite side of a runner, and subtract in the direction measured to find the width." I do that the instructions say, but the test points don't appear. Any help please? Thanks!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Viscoelastic Fluid Flows using OpenFOAM The solver viscoelasticFluidFoam	jovani	OpenFOAM Running, Solving & CFD	475	January 13, 2023 09:21
GPU Linear Solvers for OpenFOAM	gocarts	OpenFOAM Announcements from Other Sources	37	August 17, 2022 15:22
ActuatorDiskExplicitForce in OF2.1. Help	be_inspired	OpenFOAM Programming & Development	10	September 14, 2018 12:12
[swak4Foam] swak4foam building problem	GGerber	OpenFOAM Community Contributions	54	April 24, 2015 17:02
CFX Post: Problems with moving point cloud for changing time steps	spatialtime	CFX	0	December 7, 2009 05:56

August 15, 2012, 15:00		#2
dmilano Member Join Date: Mar 2012 Posts: 72 Rep Power: 14	This is a typo in the manual. use shift+click instead.

August 15, 2012, 15:48		#3
madzero New Member M4dZ3r0 Join Date: Aug 2012 Posts: 2 Rep Power: 0	Well, initially when I used shift+left-click, didn't show any value in the table of probe points, but after almost press every key of keyboard+left-click and note that there appeared no value, I used again shift+left-click and new values appears in the table of probe points. Thanks for the help!