|
[Sponsors] |
Boundary Condition for ducted wind turbine using FLUENT |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 28, 2009, 02:29 |
Boundary Condition for ducted wind turbine using FLUENT
|
#1 |
New Member
Boris Styward
Join Date: Oct 2009
Posts: 6
Rep Power: 17 |
i have a problem with my thesis using FLUENT, the problem is i have to simulate a wind turbin in duct, the main problem what is the right boundary condition for this situation?
can i use pressure inlet for the inlet, and pressure outlet for the outlet, or mass flow inlet for the inlet and pressure outlet for the outlet. What is the advantages and disadvantages if i use that combination or the other combinations? i'm sorry, i've made a same thread, but in a wrong sub-forum, maybe this is the right room Thank you FYI |
|
October 28, 2009, 06:21 |
|
#2 |
New Member
Join Date: Sep 2009
Posts: 10
Rep Power: 17 |
I'm sorry, but you are wrong here either.
Your Forum will be: -> ANSYS -> FLUENT Concerning your problem: You can use both combinations you named. It depends on your knowlege about measurements and the real conditions. You can do any combination of boundary conditions except for: velocity - mass flow velocity - velocity mass flow - mass flow (they are violating continuity equation [incompressible flows]) |
|
October 28, 2009, 12:45 |
|
#3 |
New Member
Boris Styward
Join Date: Oct 2009
Posts: 6
Rep Power: 17 |
oouww, i'm sorry because i'm a newbie here, hehehe
but thanks a lot for your information |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SymmetryPlane Boundary Condition | raytracer | OpenFOAM Running, Solving & CFD | 0 | July 11, 2008 18:04 |
fluent boundary condition | brusly | FLUENT | 1 | March 15, 2007 07:18 |
How to set boundary condition in Fluent for the fo | Peiyong | FLUENT | 1 | November 10, 2006 12:44 |
How to implement H1 Boundary Condition in Fluent? | Jake | FLUENT | 0 | September 29, 2003 12:41 |
How to resolve boundary condition problem? | sam | FLUENT | 2 | July 20, 2003 03:19 |