 |
 |
 |
|
|
|
[Sponsors] | ||||
September 6, 2008, 14:16
|
FloWorks Solver stuck
|
#1 |
|
Guest
Posts: n/a
|
After the solver generates and stores the mesh, it gets stuck during the "collecting surface goals" step. This step is part of "preparing data for calculation." I have successfully run FloWorks before, but now there is no progress after hours of waiting. Has anyone else had this problem?
|
|
|
||
|
September 16, 2008, 00:11
|
Re: FloWorks Solver stuck
|
#2 |
|
Guest
Posts: n/a
|
Hi Daniel, Maybe you can try my following advice: 1. suppress your surface goal and start your EFD solver again to confirm your problem. 2. refine your surface mesh to confirm your mesh if resolved well.
|
|
|
|
||
|
September 17, 2008, 08:33
|
Re: FloWorks Solver stuck
|
#3 |
|
Guest
Posts: n/a
|
Hi Daniel,
I had the same problem with EFD.V5. What kind of problem do you want to simulate? |
|
|
|
||
|
September 17, 2008, 16:20
|
Re: FloWorks Solver stuck
|
#4 |
|
Guest
Posts: n/a
|
I use EFD.Lab. No problems here.
Cheers Nick |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A New Solver for Supersonic Combustion | nakul | OpenFOAM Announcements from Other Sources | 19 | February 27, 2024 10:44 |
| [Other] A New Solver for Supersonic Combustion | nakul | OpenFOAM Community Contributions | 20 | February 22, 2019 10:08 |
| Quarter Burner mesh with periosic condition | SamCanuck | FLUENT | 2 | August 31, 2011 12:34 |
| Working directory via command line | Luiz | CFX | 4 | March 6, 2011 21:02 |
| why the solver reject it? Anyone with experience? | bearcat | CFX | 6 | April 28, 2008 15:08 |
Linear Mode
