FLOEFD does not see the flow

denizcancinar · August 29, 2024, 04:41

Hello everyone,

There is a problem with my desired flow. Normally the flow should be gone by starting of the valve to the end. You can see the attached image 1. Computational domain is created by software and it is not that I want to. Tried to edit computational domain but I have faced an error with the boundary conditions. As can be seen in the image 2 the fluid actually goes through all geometry.

What could be the problem? Thanks in advance.

native · September 3, 2024, 09:12

Hi Denizcan,

some thoughts on your problem:

Did you select internal simulation type?
Does your computational domain cover the complete CAD geometry (small black frame in both figures)?
Is the CAD model completely closed (i.e. watertight)?
Which boundary conditions did you choose?

Regards
Florian

September 3, 2024, 09:12		#2
native New Member Florian Join Date: Feb 2015 Location: Germany Posts: 18 Rep Power: 11	Hi Denizcan, some thoughts on your problem: Did you select internal simulation type? Does your computational domain cover the complete CAD geometry (small black frame in both figures)? Is the CAD model completely closed (i.e. watertight)? Which boundary conditions did you choose? Regards Florian

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Subject: Request for Numerical and Measured Data on Turbulent Flow in Ducts and Other	Dr Youssef Hafez	Main CFD Forum	3	April 12, 2024 09:32
Intuition for why flow follows convex surfaces	lopp	Main CFD Forum	47	February 1, 2022 14:14
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 06:21
Different flow patterns in CFX and Fluent	avi@lpsc	FLUENT	4	April 8, 2012 07:12
Flow meter Design	CD adapco Group Marketing	Siemens	3	June 21, 2011 09:33