Modeling Centrifugal fan (blower)! Need Help!

namshaheb · November 23, 2020, 19:18

Hello All:
I am using Solidworks Flow Simulation for electronics cooling. I need to model a centrifugal fan as Internal Fan. I do not have blade but I have the Fan Curve. So, how I model the inlet and outlet of the fan? Flow is coming from both side axially and leaving at normal angle (centrifugal pump works the same way). I was looking at Solidworks website and found an post where they said by showing a picture "this is wrong way to model it" , but they did not show what is the correct way to model it!
Have anyone modeled it before? I think Mr. @Boris_M has some deep background in these softwares (FloTherm, FloEFD, 6SigmaET).

Please !
Thanks!
Nam

EmmTheof84 · December 3, 2020, 08:05

Can you share a link of the "wrong way to model it"
Also, please share a screenshot of where your fan is located in your model

namshaheb · December 30, 2020, 11:54

Quote:

Originally Posted by EmmTheof84

Can you share a link of the "wrong way to model it"
Also, please share a screenshot of where your fan is located in your model

Hi: Thank you for your reply! I got communication from Solidworks. They will update their help documents, because it was misleading info.

November 23, 2020, 19:18	Modeling Centrifugal fan (blower)! Need Help!	#1
namshaheb New Member Nam Shaheb Join Date: Nov 2020 Posts: 3 Rep Power: 6	Hello All: I am using Solidworks Flow Simulation for electronics cooling. I need to model a centrifugal fan as Internal Fan. I do not have blade but I have the Fan Curve. So, how I model the inlet and outlet of the fan? Flow is coming from both side axially and leaving at normal angle (centrifugal pump works the same way). I was looking at Solidworks website and found an post where they said by showing a picture "this is wrong way to model it" , but they did not show what is the correct way to model it! Have anyone modeled it before? I think Mr. @Boris_M has some deep background in these softwares (FloTherm, FloEFD, 6SigmaET). Please ! Thanks! Nam

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to build current blower fan model in Flotherm	eric0722	FloEFD, FloWorks & FloTHERM	3	January 2, 2021 03:36
centrifugal fan modeling	hmasenger	CFX	9	August 9, 2014 07:17
Modeling a centrifugal fan	saisanthoshm88	CFX	2	May 25, 2011 09:30
Modeling of centrifugal fan in CFD	Simon Williams	Main CFD Forum	3	February 20, 2009 16:00
Blower modeling use Fan B.C	Saturn	FLUENT	0	September 22, 2004 05:11

December 3, 2020, 08:05		#2
EmmTheof84 New Member Manolis Theofilos Join Date: Nov 2020 Location: London Posts: 11 Rep Power: 6	Can you share a link of the "wrong way to model it" Also, please share a screenshot of where your fan is located in your model