|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
swadish
Join Date: Dec 2014
Posts: 2
Rep Power: 0 ![]() |
Hi,
I am trying to run to a simulation for a fairly large file, with a basic mesh. When I try to run it, solidworks goes into not responding mode and the geometry preparation window is running forever(about 2 hours now). How do I proceed? Computer specs are: Intel Xeon 3.00 GHz processor, 32 GB Ram, 5GB Nvidia Graphics Card. |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Disabled
Join Date: Jul 2009
Posts: 616
Rep Power: 24 ![]() |
This is hard to tell. It can take some time but 2 hours should be too long.
It could be a bug but also a problem with the geometry. Ideally send it to your SW support. What SW version are you using? Have you tried the latest version in case there is a bug and it is fixed? Boris |
|
![]() |
![]() |
![]() |
Tags |
simulation, specifications, system |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] an error in Calculator's equation | immortality | ParaView | 12 | June 29, 2021 01:10 |
[blockMesh] blockMesh with double grading. | spwater | OpenFOAM Meshing & Mesh Conversion | 92 | January 12, 2019 10:00 |
error compiling modified applications | yvyan | OpenFOAM Programming & Development | 21 | March 1, 2016 05:53 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 20:08 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 16:16 |