|
[Sponsors] |
November 5, 2005, 08:05 |
About the using of AutoGrid 5
|
#1 |
Guest
Posts: n/a
|
How can I make a non-axisymmetric endwall structure by using AutoGrid 5.1? I think it should be achieved by the 3D technological effects, but the user manual talks a little in this subject. Will some one please help me? Thanks a lot!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Autogrid: discontinuity of 90 degrees in shroud | Eric Joubarne | Fidelity CFD | 1 | July 21, 2009 05:34 |
autogrid:leading edge | liu wangkou | Fidelity CFD | 2 | August 22, 2008 20:42 |
HELP ME!!! I cannot import blade in autogrid! | Nicola | Fidelity CFD | 2 | February 1, 2008 04:38 |
AUTOGRID and AUTOBLADE strengths and limitations | Haider | Fidelity CFD | 1 | December 6, 2007 21:24 |
Autogrid | ked | Fidelity CFD | 1 | August 19, 2003 11:36 |