 |
 |
 |
|
|
|
[Sponsors] | ||||
November 8, 2004, 10:16
|
about boundary conditions
|
#1 |
|
Guest
Posts: n/a
|
there is a segregator with bulb and stators.how to set the boundary conditions. i set vecolity and static temperature at inlet,static pressure at outlet.however,after 2000 steps,global residual is about -0.5,massflow error between inlet and outlet is 10%. grid quality:min orthogonality is 9.46,max aspect ratio is 10000(because of bulb). thank you very much!
|
|
|
||
|
May 11, 2012, 08:45
|
|
#2 |
|
New Member
yujiabeizi
Join Date: May 2012
Posts: 8
Rep Power: 14  |
u can set total pressure at inlet and total temperature ,static temperature at outlet.
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Burgerbs equation non constant Boundary Conditions Initial Conditions | arkangel | OpenFOAM Running, Solving & CFD | 1 | October 2, 2008 15:48 |
| Boundary conditions for turbulent boundary layer | Thomas | FLUENT | 1 | June 17, 2008 06:14 |
| boundary conditions for boundary layer flow | A. Al-zoubi | CFX | 0 | November 3, 2007 08:11 |
| Integral boundary conditions turbulent intensitylength boundary conditions | olesen | OpenFOAM Running, Solving & CFD | 0 | July 27, 2006 08:18 |
| boundary conditions | Jason Jordan | FLUENT | 0 | June 26, 2001 18:12 |
Linear Mode
