 |
 |
 |
|
|
|
[Sponsors] | ||||
April 7, 2022, 06:47
|
AutoGrid5 enforce cell width at blade wall
|
#1 |
|
New Member
Rigel F. do C.
Join Date: Jan 2017
Posts: 1
Rep Power: 0  |
Hi,
I would just like to let the community knows that the above option (found within the 3D mesh control options) may lead AutoGrid5 to crash / never stop meshing if your mesh size is considerably big. If this is happening to you, you might consider disabling this option. Hope it helps, |
|
|
|
|
 |
| Tags |
| autogrid5, crashing, mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 06:38 |
| Neighboring cells in tetrahedral mesh | vishwesh | OpenFOAM Programming & Development | 9 | November 10, 2017 08:06 |
| Wrong flow in ratating domain problem | Sanyo | CFX | 17 | August 15, 2015 07:20 |
| Question about wall cell width for conjugate heat transfer | Anna Tian | Main CFD Forum | 0 | May 6, 2013 14:01 |
| Question about the way to calculate the maximum wall cell width | Anna Tian | Main CFD Forum | 9 | October 23, 2012 19:05 |
Linear Mode
