Set up of head waves case

nollnoll · April 8, 2014, 08:41

Hi All,

I am new to this forum but have been lurking around.

I am trying to evaluate a set of hulls 8,5m long, in both smooth water (using something based of the DTMB tutorial) and with the intention to also do this in some waves. The absolute main concern is resistance.

Is there a tutorial for this or an example case set up for the waves case? (the smooth water one is done/understood)

Kind regards
Elastic Sparrow

Rombzh · April 9, 2014, 06:49

Hi,

I don't know any tutorials but I think you might find some guidelines here :
http://www.numeca.com/en/resources/c...ion-simulation
You then have a link to paper.

Besides, in your FineMarine folder, in _data/isis/Src there is a spreadsheet called setup_for_wave_generation that should help you.

nollnoll · April 10, 2014, 04:13

Many thanks, will give that a try.
When looking around I found two different papers on their site, links below.

http://www.numeca.com/sites/numeca/f...n_-_onr_1_.pdf

and

http://www.numeca.com/sites/numeca/f..._et_al._1_.pdf

Kind regards
Elastic Sparrow

April 8, 2014, 08:41	Set up of head waves case	#1
nollnoll New Member nollnoll Join Date: Apr 2012 Posts: 9 Rep Power: 14	Hi All, I am new to this forum but have been lurking around. I am trying to evaluate a set of hulls 8,5m long, in both smooth water (using something based of the DTMB tutorial) and with the intention to also do this in some waves. The absolute main concern is resistance. Is there a tutorial for this or an example case set up for the waves case? (the smooth water one is done/understood) Kind regards Elastic Sparrow

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to Initialise my LES case using my RANS case is there any utility for it ?	Alhasan	OpenFOAM Running, Solving & CFD	2	May 10, 2014 01:14
Hydrofoil case set up	goldbeard	OpenFOAM Running, Solving & CFD	2	March 29, 2013 16:15
[GAMBIT] Ask about how to set up geometry and mesh for moving mesh case	g-wagon	ANSYS Meshing & Geometry	35	September 10, 2012 09:03
How to set up the inlet boundary condition for a low pressure case?	beastieboys6	FLUENT	3	April 10, 2012 23:46
Instalation on ubuntu 710	basilwatson	OpenFOAM Installation	17	March 16, 2012 21:16

April 9, 2014, 06:49		#2
Rombzh Member Romain Join Date: May 2009 Posts: 40 Rep Power: 17	Hi, I don't know any tutorials but I think you might find some guidelines here : http://www.numeca.com/en/resources/c...ion-simulation You then have a link to paper. Besides, in your FineMarine folder, in _data/isis/Src there is a spreadsheet called setup_for_wave_generation that should help you.

April 10, 2014, 04:13		#3
nollnoll New Member nollnoll Join Date: Apr 2012 Posts: 9 Rep Power: 14	Many thanks, will give that a try. When looking around I found two different papers on their site, links below. http://www.numeca.com/sites/numeca/f...n_-_onr_1_.pdf and http://www.numeca.com/sites/numeca/f..._et_al._1_.pdf Kind regards Elastic Sparrow