 |
 |
 |
|
|
|
[Sponsors] | ||||
October 2, 2013, 09:30
|
Difine patch
|
#1 |
|
New Member
saman sameti
Join Date: Oct 2013
Posts: 1
Rep Power: 0  |
Hi Dear all
I create a blade and I want to mesh it. But I use the wind turbine wizard. So I must define patch (I think input and output) for the domain that created by wind turbine wizars. PLease help me for way to defien this in IGG or outoGrid5. Thanks for your help. |
|
|
|
|
|
November 3, 2013, 15:03
|
|
#2 |
|
Senior Member
Hamid Zoka
Join Date: Nov 2009
Posts: 293
Rep Power: 19 |
If you are meshing your blade in Autogrid5 you don't need to define any patch, cause it is done automatically. But in case you are to make your own domain in IGG you should define each boundary.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| y+ and u+ values with low-Re RANS turbulence models: utility + testcase | florian_krause | OpenFOAM | 114 | August 23, 2023 06:37 |
| [GAMBIT] periodic faces not matching | Aadhavan | ANSYS Meshing & Geometry | 6 | August 31, 2013 12:25 |
| CheckMeshbs errors | ivanyao | OpenFOAM Running, Solving & CFD | 2 | March 11, 2009 03:34 |
| [Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 09:19 |
| Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 06:12 |
Linear Mode
