Improving the Surface Mesh in border Zone?!?

BlnPhoenix · October 16, 2014, 04:53

Hello,

can somebody please explain how to use the "adding sources" feature as in the damper tutorial. How can I setup a source in a new case? Are the coordinates i in mm??

Thanks a lot!!

BlnPhoenix · October 17, 2014, 05:46

It's me again. I found out about the axis that you can make visible: Still in my geometry (similiar to the damper tutorial) i have x-axis from 0 to 1000, y-axis from 0-500 and z-axis from 0-500. When i want to add a source (e.a. a cone) and type in the coordinates i want it to show up, nothing happens after "improve surface mesh" button be clicked... frustrating..

can anybody please give me a hint with this??!

thanks a lot

BlnPhoenix · November 14, 2014, 11:11

Hey, had anyone ever luck with using refinement sources in engrid??

It would be much appreciated if someone could help me using this program..

Thanks!

October 16, 2014, 04:53	Improving the Surface Mesh in border Zone?!?	#1
BlnPhoenix Senior Member Join Date: Aug 2014 Location: Germany Posts: 292 Rep Power: 14	Hello, can somebody please explain how to use the "adding sources" feature as in the damper tutorial. How can I setup a source in a new case? Are the coordinates i in mm?? Thanks a lot!!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 09:54
[GAMBIT] periodic faces not matching	Aadhavan	ANSYS Meshing & Geometry	6	August 31, 2013 12:25
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 05:24
[snappyHexMesh] Layers don't fully surround surface	EVBUCF	OpenFOAM Meshing & Mesh Conversion	14	August 20, 2012 05:31
[ICEM] Automatic mesh generation script surface intersection problem	stuart23	ANSYS Meshing & Geometry	0	May 13, 2011 02:10

October 17, 2014, 05:46		#2
BlnPhoenix Senior Member Join Date: Aug 2014 Location: Germany Posts: 292 Rep Power: 14	It's me again. I found out about the axis that you can make visible: Still in my geometry (similiar to the damper tutorial) i have x-axis from 0 to 1000, y-axis from 0-500 and z-axis from 0-500. When i want to add a source (e.a. a cone) and type in the coordinates i want it to show up, nothing happens after "improve surface mesh" button be clicked... frustrating.. can anybody please give me a hint with this??! thanks a lot

November 14, 2014, 11:11		#3
BlnPhoenix Senior Member Join Date: Aug 2014 Location: Germany Posts: 292 Rep Power: 14	Hey, had anyone ever luck with using refinement sources in engrid?? It would be much appreciated if someone could help me using this program.. Thanks!