[cfd_buddy24]

Hi everybody,

I get the following error:

WARNING: Domain bounds- xmin: -3.200000; ymin: -3.200000; zmin: -3.200000; xmax: 3.200000; ymax: 3.200000; zmax: 3.200000;
(Rank 0) FATAL_ERROR: Geometry was detected outside the domain. Please either adjust the domain size or create the initial configuration such that the geometry is at its maximum extent

I don't understand why because my geometry is about 1.6 meters in each coordinate direction and the domain size under run parameters is larger.
Does anyone know this problem and can help me to solve it? Thanks a lot!

[MFitl]

Just a few quickm thoughts:
- Mismatch of unities of geometry and domain (mm vs. m)
- Center of geometry outside the domain
- Error during import ==> one (or more) points ar far outside the domain

Matthias