[dkswnsgud98]

Hello, could anyone kindly provide me a method to make iteration for the outlet pressure value? Currently, I am manually increase pressure value, hoping that it will converge. My case setup is steady state, cycles, and supersonic.

Thank you so much in advance!

[bb91936762]

Hey Jay,


Based on the case setup you described, the outlet pressure should be set to zero pressure gradient, this will allow the pressure to vary based on the inlet boundary conditions, rather than forcing an outlet pressure until you get convergence. You can refer to the "Supersonic Steady Channel Laminar" example case in Studio for reference.

Thanks,

[dkswnsgud98]

Dear Basu,

Thank you so much!

Sincerely,
Jay