|
[Sponsors] |
March 20, 2024, 20:47 |
Create seals in studio v3.1
|
#1 |
New Member
Chen Hao
Join Date: Jan 2023
Posts: 5
Rep Power: 3 |
Hey everyone,
When I used ”Seal>Configuration” create seals for ports of a two-stroke engine in CONVERGE Studio v3.1, the following error occurs. “FATAL_ERROR: There is an error in the extrusion algorithm. Overlapping triangles were detected.” How to solve this problem? Also I noticed that sealing can also be achieved through INTERFACE, but I don't know how to do it in a two-stroke engine with port seal. Thanks. |
|
March 29, 2024, 15:25 |
|
#2 |
Senior Member
Kislaya Srivastava
Join Date: Sep 2017
Location: Convergent Science, Northville MI
Posts: 165
Rep Power: 9 |
Hello Chen,
Use the Diagnosis Dock to check for Overlapping triangles around your selected sealing edges/boundaries. If they are present, please fix them before attempting to create the seals. Information on how to create and use Sealing INTERFACEs can be found in our v3.1 CONVERGE Studio manual. Sincerely, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Using createPatch and cyclicAMI in FOAM Extend to create periodicbox | manuc | OpenFOAM Running, Solving & CFD | 1 | April 12, 2022 11:36 |
create the file *.foam | phongstar | OpenFOAM | 12 | October 14, 2018 18:06 |
[GAMBIT] How to plot S pipe | mariam.sara | ANSYS Meshing & Geometry | 36 | November 7, 2013 15:22 |
CFX11 + Fortran compiler ? | Mohan | CFX | 20 | March 30, 2011 18:56 |
Gambit-how to create a wireframe face from so many edges? | gholamghar | ANSYS | 0 | February 18, 2011 07:22 |