Problem with the 3D-results

Losinyao · June 7, 2023, 11:08

Hello everyone!
I did a simulation of a dual-fuel engine with n-heptane and methane based on the SAGE model of the dual-fuel engine in the official example.
In the result output, the results in line plotting are from -145 to 125 degrees depending on the crankshaft rotation angle (which matches my setup for the case)
I used post-processing 3D to cover the output file, but in Tecplot, the angle of reads only -145 to 7 degrees.
How can I deal with this situation?

awaikar · June 8, 2023, 13:51

Can you please provide more specifics? The 3D output frequency and the frequency for *.out files is controlled differently. You can change that under Case Setup > Output/Post-Processing > output files > Writing time intervals

June 7, 2023, 11:08	Problem with the 3D-results	#1
Losinyao New Member Luo Xinyao Join Date: Jun 2023 Location: Tokyo Posts: 5 Rep Power: 3	Hello everyone! I did a simulation of a dual-fuel engine with n-heptane and methane based on the SAGE model of the dual-fuel engine in the official example. In the result output, the results in line plotting are from -145 to 125 degrees depending on the crankshaft rotation angle (which matches my setup for the case) I used post-processing 3D to cover the output file, but in Tecplot, the angle of reads only -145 to 7 degrees. How can I deal with this situation?

June 8, 2023, 13:51		#2
awaikar New Member Ameya Waikar Join Date: Jun 2021 Location: Madison Posts: 11 Rep Power: 5	Can you please provide more specifics? The 3D output frequency and the frequency for .out files is controlled differently. You can change that under Case Setup > Output/Post-Processing > output files > Writing time intervals* __________________ Ameya Waikar Support Engineer II New Applications https://convergecfd.com/

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
I have a problem with my results from FLUENT when I imported in ORIGIN	Benaissa Sabrina	Mesh Generation & Pre-Processing	0	February 11, 2018 04:44
Serrated Fin Vs Straight Fin - CHT Problem - Results Making No Sense	Andrew Norfolk	CFX	13	September 27, 2016 15:39
[OpenFOAM] Color display problem to view OpenFOAM results.	Sargam05	ParaView	16	May 11, 2013 01:10
problem with results pipe with reaction	TallesC	CFX	1	February 19, 2013 18:00
Problem in obtaining final results	samurai_01	FLUENT	2	November 30, 2012 13:54