Combustion model enable time period

Hongjie · April 20, 2022, 00:41

I would like to ask you all a question. I was performing engine simulation calculations and found that after I set the use time of the combustion model to be short, the combustion was not complete at the end of the combustion model, is there any way I can continue to calculate the combustion afterwards without recalculating?

Looking forward to your advice.

MFGT · April 23, 2022, 08:53

Hi,

you can take a restartfile from before end of combustion model, extend the duration and restart the case.

April 20, 2022, 00:41	Combustion model enable time period	#1
Hongjie New Member Hongjie Zhou Join Date: Feb 2022 Posts: 8 Rep Power: 4	I would like to ask you all a question. I was performing engine simulation calculations and found that after I set the use time of the combustion model to be short, the combustion was not complete at the end of the combustion model, is there any way I can continue to calculate the combustion afterwards without recalculating? Looking forward to your advice.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[General] Extracting ParaView Data into Python Arrays	Jeffzda	ParaView	30	November 6, 2023 22:00
Elastic or Plastic Deformations in OpenFOAM	NickolasPl	OpenFOAM Pre-Processing	36	September 23, 2023 09:22
laplacianFoam with source term	Herwig	OpenFOAM Running, Solving & CFD	17	November 19, 2019 14:47
Superlinear speedup in OpenFOAM 13	msrinath80	OpenFOAM Running, Solving & CFD	18	March 3, 2015 06:36
Micro Scale Pore, icoFoam	gooya_kabir	OpenFOAM Running, Solving & CFD	2	November 2, 2013 14:58

April 23, 2022, 08:53		#2
MFGT Senior Member Tobias Join Date: May 2016 Location: Germany Posts: 295 Rep Power: 11	Hi, you can take a restartfile from before end of combustion model, extend the duration and restart the case.