[mohmdasher]

Hi,

I have an assembly drawing in Catia, as per standard procedure, I converted the assembly into a single part drawing and exported as STL.

I imported this STL in Converge, the import was successful, however the following error was flashed in message log

ERROR: Error parsing STL input line OLID

What does this error mean and its resolution.
---------------------------------
Here is the full message log:
--------------------------------------------------------------------------------
OpenGL: using old rendering methods (deprecated GL calls).
--------------------------------------------------------------------------------
Compression tolerance to be calculated per boundary.
Reading STL ASCII data from file E:/CAD/Cylinder 1000.stl
2582546 triangles, 7747638 vertices.
Reading in triangles...
ERROR: Error parsing STL input line OLID
Compressing boundary: Not Assigned...
Final vertex count 1335245. 6412393 removed.
Constructing Objects.
Finish importing E:/CAD/Cylinder 1000.stl
E:/CAD /Cylinder 1000.stl imported in 25.4 seconds
Vcompress deleted 0 vertices
Open edges compression done in 2.2 seconds
0 vertices has been processed, 0 removed

[crajath]

Are you getting this error in Converge Studio or when you run the Converge solver?

[mohmdasher]

I'm getting the error in the Converge studio, its the first message as soon as i import the STL file.

[crajath]

An ASCII STL file must begin with the line

solid name

The string name is optional. If name is omitted then there must be a space after solid. Can you check to make sure your STL file has this line?

From the error message it looks like the s in solid is missing in the file.

[mohmdasher]

It has the said "solid name" initialisation, following are a few lines from the beginning of the file for your kind perusal..


solid CATIA STL
facet normal -1.557276e-001 2.089441e-002 -9.875790e-001
outer loop
vertex 5.240067e-001 7.499817e+001 -2.375110e+002
vertex 2.8..............continues.............

[crajath]

Asher

I am not sure what the issue could be. The error points to the first line of the file but everything looks okay. What version of Studio are you using?

You can reach out to us at support@convergecfd.com (US); supportEU@convergecfd.com (EU) or support.in@convergecfd.com (India). We would be happy to take a look at your file and resolve the issue

Thank you