|
[Sponsors] |
May 14, 2020, 04:06 |
Region ID leak
|
#1 |
New Member
Shimon
Join Date: Oct 2019
Posts: 1
Rep Power: 0 |
Hi forum,
When i updated my converge version from 2.4 to 3.0, the solver started to show me the following warning: Failed to initialize region id for some cells, forced initialization may cause a region id leak. This warning affected the smoothness of my plots, especially the volume/CA plot. I tried to disable the shared_memory_flag and to define a higher seal_tol value for my rotating seal geometry, it didn't worked... Would appreciate your help. Thanks! |
|
May 22, 2020, 08:14 |
|
#2 |
New Member
David Rowinski
Join Date: Dec 2015
Location: Madison, WI
Posts: 14
Rep Power: 10 |
Hello and thank you for your message. For a geometry using sealing to separate regions, there may not be a single set of boundaries you can use to enclose each region. To reduce the region ID leakage as much as possible, make sure to avoid the dependent region ID on boundaries wherever possible. You can also make use of the new sealing feature in 3.0 to seal to boundary sets, in case that helps to break down your seal-to boundary into separate boundaries for region identification. If those do not work, we can use a user defined function for region identification. Feel free to let us know if you have any other questions, or forward your case to support@convergecfd.com.
Best regards, David
__________________
David H. Rowinski, Ph.D. Principal Engineer Convergent Science, Inc. Madison, WI, USA david.rowinski@convergecfd.com www.convergecfd.com |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error when solving p_rgh | bob94 | OpenFOAM | 0 | March 17, 2020 08:12 |
Problem simulating the temperature rise in a composite material (chtMultiRegionFoam) | Adam_K | OpenFOAM Running, Solving & CFD | 2 | March 27, 2019 06:51 |
[mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 18:57 |
[Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
[Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 08:19 |