 |
 |
 |
|
|
|
[Sponsors] | ||||
February 23, 2018, 04:12
|
Prediction difference
|
#1 |
|
Member
Yaopeng Li
Join Date: Dec 2017
Location: Lund, Sweden
Posts: 50
Rep Power: 9  |
When I used MPI to calculate a DISI case, I found huge difference in pressure prediction when different number of processors are used (8 VS. 32). Using less number of processors results in higher peak pressure (1 MPa higher) and advanced ignition timing. Does anyone meet the similar situation, is it reasonable?
Thank you very much for your attention and help. Best regards, Yaopeng |
|
|
|
|
|
February 23, 2018, 11:32
|
|
#2 | |
|
Member
Yaopeng Li
Join Date: Dec 2017
Location: Lund, Sweden
Posts: 50
Rep Power: 9 |
Quote:
|
||
|
|
|
||
 |
| Tags |
| mpi, number of processors, prediction difference |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is there a difference between Riemann solvers and characteristic based solvers? | linkamp | Main CFD Forum | 3 | February 18, 2016 10:12 |
| [snappyHexMesh] snappyHexMesh and cyclic boundaries | Ruli | OpenFOAM Meshing & Mesh Conversion | 2 | December 9, 2013 07:51 |
| Difference in velocity prediction by kepsilon and komega | Chander | CFX | 3 | September 19, 2011 20:11 |
| Periodic Boundary Condition for upwind difference | yohey44 | Main CFD Forum | 0 | October 27, 2010 14:10 |
| [General] paraview - plotting difference to reference data | joewe | ParaView | 0 | August 30, 2010 19:01 |
Linear Mode
