[Nana_W]

I want to simulation a two_d case at cylindrical coordinate system. I used a 3D surface which is a sector (angle is 5 deg.) actually. The rotational axis is y axis. I have clicked on the 'Has rotational axis' box when setting up BOUNDARY. However, when CONVERGE run this case it had an error that 'the normal directions of TWO_D boundaries must be aligned in z direction'. Can CONVERGE run this kind of TWO_D case?


Nana

[Nana_W]

Originally Posted by Nana_W

I want to simulation a two_d case at cylindrical coordinate system. I used a 3D surface which is a sector (angle is 5 deg.) actually. The rotational axis is y axis. I have clicked on the 'Has rotational axis' box when setting up BOUNDARY. However, when CONVERGE run this case it had an error that 'the normal directions of TWO_D boundaries must be aligned in z direction'. Can CONVERGE run this kind of TWO_D case?


Nana

I have emailed the support of CONVERGE. They cannot do 2D cylindrical coordinates.