 |
 |
 |
|
|
|
[Sponsors] | ||||
April 24, 2017, 02:03
|
questions on wall film simulation
|
#1 |
|
New Member
Join Date: Feb 2017
Posts: 5
Rep Power: 9  |
Dear Support,
Can you please offer more explanation on the following warnings: WARNING: The total mass of removed parcels is 3.29157e-10 kg Warning: flux scaling factor in film evap should be greater than 0 and less than 1.1, current value is -0.109818. Warning: flux scaling factor in film evap should be greater than 0 and less than 1.1, current value is -0.000947. 1. Why is a parcel removed? and 2. what is the flux scaling factor? I cannot find this term in the manual. Thanks a lot. |
|
|
|
|
|
April 24, 2017, 12:03
|
|
#2 |
|
Member
Yajuvendra Shekhawat
Join Date: Mar 2017
Location: Convergent Science, Madison WI
Posts: 51
Rep Power: 9 |
Hi learner111,
In some cases (ex: sealing) it might happen that some parcels are removed from the computational domain. But this should not affect your results if the amount of mass removed is tiny. The flux scaling factor is related to a temporary change of the film evaporation algorithm and it has been removed, the latest v2.3 should not have this warning. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Some questions about flow boiling simulation in Fluent | beastieboys6 | FLUENT | 8 | November 21, 2017 00:47 |
| Eulerian wall film (Mass convergence stabilized, film transport height varies!) | Jeeloong | FLUENT | 0 | February 11, 2016 21:37 |
| Problem with an old Simulation | FrankW | CFX | 3 | February 8, 2016 05:28 |
| simulation of wall with holes | bitacovir | CFX | 2 | October 24, 2013 07:54 |
| UDF for wall slipping | HFLUENT | Fluent UDF and Scheme Programming | 0 | April 27, 2011 13:03 |
Linear Mode
