 |
 |
 |
|
|
|
[Sponsors] | ||||
How to Model the On/Off Behavior of a Semiconductor Chip Using COMSOL |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 15, 2023, 06:57
|
How to Model the On/Off Behavior of a Semiconductor Chip Using COMSOL
|
#1 |
|
New Member
Phillip Dalton
Join Date: Sep 2023
Posts: 1
Rep Power: 0  |
How can an IGBT or MOSFET semiconductor chip imitate the electrothermal performance of a semiconductor power module? My present strategy is to construct a flat cube, set it to be formed of silicon, and then alter the electrical conductivity of the silicon to replicate the state of the IGBT chip, but the results are not optimal; thus, how can I simulate a semiconductor chip?
Last edited by tqueibi; September 18, 2023 at 06:21. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 18:38 |
| Superimposing 2 Velocity fields For Model inputs in Comsol | f.black | COMSOL | 0 | August 2, 2017 10:35 |
| Wrong flow in ratating domain problem | Sanyo | CFX | 17 | August 15, 2015 07:20 |
| Error in Two phase (condensation) modeling | adilsyyed | CFX | 15 | June 24, 2015 20:42 |
| manualInjection model in sprayFoam | Mentalo | OpenFOAM Running, Solving & CFD | 1 | April 2, 2014 10:29 |
Linear Mode
