 |
 |
 |
|
|
|
[Sponsors] | ||||
December 11, 2020, 06:12
|
COMSOL parametric scanning
|
#1 |
|
Senior Member
Join Date: Feb 2020
Posts: 114
Rep Power: 6  |
I find that when I calculate something that geometric parameters should be changed using parametric scanning, it will show some error after calculating several parameters, not all of them.However, when I try to calculate the case it shows error before, not using scanning, it just works fine.What's more, it can calculate to the end of the parameter's list when the parameter is not about geometry
 So I guess something goes wrong inside comsol.Does anyone know its reason? Or maybe it is solved in version 5.6,I'm using 5.5 |
|
|
|
|
 |
| Tags |
| comsol 5.5, parametric scanning |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Parametric study by Ansys Workbench | Sahar FaPerhu | ANSYS | 17 | August 23, 2017 04:29 |
| Gmsh: Preparing mesh for use in COMSOL | StudentIB | Mesh Generation & Pre-Processing | 0 | June 21, 2017 17:00 |
| Comsol (4.3): convert parametric surface into block? | sgalaz | COMSOL | 0 | November 9, 2012 10:20 |
| Pros and Cons for CFX, CFdesign, COMSOL | Val | Main CFD Forum | 3 | June 10, 2011 03:20 |
| pressure distribution in water flow, differences in icoFoam and COMSOL | deniggo | OpenFOAM Running, Solving & CFD | 14 | September 30, 2010 04:48 |
Linear Mode
