How to make inner boundaries selectable in COMSOL?

Estiivan · April 7, 2017, 10:34

Probably quite simple beginner's COMSOL question. I am trying to have a block and a cylinder inside the block. If I draw first block and put cylinder inside of block in the middle, how can I make it so that volume inside cylinder would not be anymore part of block (but just of cylinder)?

I need to have boundaries of cylinder inside the block selectable. If I just put the cylinder inside the block as I have, then only the bottom and top surface of that cylinder seems to become selectable.

Estiivan · April 7, 2017, 11:03

Quote:

Originally Posted by Estiivan

Probably quite simple beginner's COMSOL question. I am trying to have a block and a cylinder inside the block. If I draw first block and put cylinder inside of block in the middle, how can I make it so that volume inside cylinder would not be anymore part of block (but just of cylinder)?

I need to have boundaries of cylinder inside the block selectable. If I just put the cylinder inside the block as I have, then only the bottom and top surface of that cylinder seems to become selectable.

Here is a picture. How can I make cylinder walls to be clickable (selectable)?

April 7, 2017, 10:34	How to make inner boundaries selectable in COMSOL?	#1
Estiivan New Member Join Date: Apr 2017 Posts: 2 Rep Power: 0	Probably quite simple beginner's COMSOL question. I am trying to have a block and a cylinder inside the block. If I draw first block and put cylinder inside of block in the middle, how can I make it so that volume inside cylinder would not be anymore part of block (but just of cylinder)? I need to have boundaries of cylinder inside the block selectable. If I just put the cylinder inside the block as I have, then only the bottom and top surface of that cylinder seems to become selectable.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2D Rotating Detonation Engine Periodic Boundaries	whitet86	FLUENT	2	June 25, 2015 12:04
OF 1.6 ext on Ubuntu 12.10 (64 bit) compilation errors	dreamilam	OpenFOAM Installation	7	April 21, 2013 06:43
[OpenFOAM] paraFoam not found	maysmech	ParaView	26	October 25, 2011 04:14
a way to make lots of money quick and easy no lies	Dob	Main CFD Forum	0	October 10, 2006 17:45
mass flux correction at outflow boundaries	Subhra Datta	Main CFD Forum	2	November 24, 2003 14:11