 |
 |
 |
|
|
|
[Sponsors] | ||||
June 2, 2014, 13:34
|
moving heater
|
#1 |
|
New Member
Join Date: Feb 2014
Posts: 10
Rep Power: 12  |
Hi,
I am trying to model heat transfer to a fluid in a rectangular duct in COMSOL. A short section of the bottom wall of the duct forms the heater. The heater is specified in terms of a rectangular step function. I would like to make the heater move with time i.e, a different section gets heated at each time instant. Is there a way to do this in COMSOL? Thanks. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HELP - Moving car simulation in fluent | Brad Wells | FLUENT | 7 | January 4, 2018 20:55 |
| Question on moving mesh, mesh velocity is really small! | ripperjack | Main CFD Forum | 2 | April 28, 2014 14:37 |
| [snappyHexMesh] jagged, ragged edges... | ziemowitzima | OpenFOAM Meshing & Mesh Conversion | 138 | July 24, 2012 00:41 |
| [Other] How to set up a dynamic mesh for a piston moving through a tube of variable diameter? | karkar | OpenFOAM Meshing & Mesh Conversion | 0 | July 4, 2012 07:54 |
| Moving mesh in Fluent | fivos | FLUENT | 0 | April 2, 2010 10:45 |
Linear Mode
