 |
 |
 |
|
|
|
[Sponsors] | ||||
FSI: Establishment of the initial stress state |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 7, 2012, 08:49
|
|
#21 |
|
Senior Member
Edmund Singer P.E.
Join Date: Aug 2010
Location: Minneapolis, MN
Posts: 511
Rep Power: 21  |
use upcoord,1000 to solve your scale issue.
|
|
|
|
|
|
May 7, 2012, 08:59
|
|
#22 |
|
Member
Join Date: Apr 2011
Posts: 32
Rep Power: 15 |
Ok, I used upcoord,1000 instead of upcoord,1 now. What I got was a deformed line instead of a deformed area. Thus, in addition to the scaling problem I have a new geometry... weird...
Did this work on my example that I posted? My ANSYS might go crazy. I "only" use the unsupported openSuse platform... 
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| High Courant Number @ icoFoam | Artex85 | OpenFOAM Running, Solving & CFD | 11 | February 16, 2017 13:40 |
| Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Linear Mode
