 |
 |
 |
|
|
|
[Sponsors] | ||||
February 6, 2012, 10:55
|
Sand grain roughness?
|
#1 |
|
New Member
Dan
Join Date: Mar 2011
Posts: 10
Rep Power: 15  |
Hello,
I would like to add roughness to a wall, I am not sure what sand grain roughness is trying to represent. Can anyone tell me how this correlates to absolute roughness? If my absolute roughness of my wall is 0.000125 inches what will my sand grain roughness be? Thanks |
|
|
|
|
|
February 4, 2015, 09:55
|
|
#2 |
|
New Member
Karanbir Sidhu
Join Date: Feb 2015
Posts: 1
Rep Power: 0 |
Hopefully this helps!! you will need to go thru some literature though.
http://ijmem.avestia.com/2012/PDF/008.pdf |
|
|
|
|
|
|
June 7, 2021, 13:58
|
|
#3 |
|
New Member
SUVECKSHYA
Join Date: May 2021
Posts: 5
Rep Power: 5 |
I too need to create rough surface in ANSYS geometry. how can it be done?
|
|
|
|
|
|
|
June 8, 2021, 06:58
|
|
#4 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,871
Rep Power: 144 |
CFX has a wall roughness model in several turbulence models. Read the documentation for details.
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| nutRoughWallFunction and Surface Roughness Documented | AlanR | OpenFOAM Programming & Development | 64 | January 6, 2024 08:13 |
| Laminar flow and wall roughness | junbbung | FLUENT | 2 | November 26, 2022 22:22 |
| Surface roughness in Flow-3d | Marco | FLOW-3D | 3 | June 3, 2018 03:15 |
| NACA standart roughness | DAK565656 | Main CFD Forum | 2 | August 24, 2005 01:47 |
| Roughness adaptation in CFX 4.4 | Bart | CFX | 1 | May 2, 2003 09:32 |
Linear Mode
