|
[Sponsors] |
![]() |
![]() |
#1 |
Senior Member
---------
Join Date: Oct 2010
Posts: 303
Rep Power: 17 ![]() |
I'm facing a difficulty in Inserting the monitor points at the right location in CFX Pre. For instance if I wanted to monitor pressure at an arbitary point on a particular surface in the domain, could some one please tell me how to specify the co ordinates such that the monitor point lies definetly some where on the surface of interest.
I see that it is not possible to even do some screen selection of the desired location and that a monitor point can only be created by specifying the co ordinates of that location which makes the task difficult.
__________________
Best regards, Santhosh. |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,816
Rep Power: 144 ![]() ![]() ![]() ![]() |
Yes, you can do screen selection of monitor point locations. Choose the select tool and click away when you are setting the coordinates.
|
|
![]() |
![]() |
![]() |
![]() |
#3 |
Senior Member
---------
Join Date: Oct 2010
Posts: 303
Rep Power: 17 ![]() |
Thanks for the reply Glenn and sorry for the abrupt question , yes I see that a screen select in this case is possible while inserting the co ordinates for the monitor point
__________________
Best regards, Santhosh. |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
only 1 of many named selections not showing up in cfx pre | mihirbhagat | CFX | 2 | April 26, 2019 04:56 |
Setting Pressure Boundary Conditions in ANSYS CFX Pre | saisanthoshm88 | CFX | 21 | February 22, 2017 16:50 |
CFX Pre - TGrid | Vivek Vasudevan | CFX | 2 | March 20, 2007 06:31 |
mesh from Workbench Simulation to Cfx Pre? | Dai | CFX | 6 | November 11, 2006 12:19 |
CFX 5.7 pre | Neser | CFX | 0 | January 27, 2005 11:22 |