Transient analysis of particle flow with Fluid-Structure Interaction (FSI)

Julian K. · September 14, 2011, 16:38

Hello!

I would like to simulate the following scenario:

- flow over an oscillator (beam) -> Fluid-Structure-Interaction (FSI)
- particle tracking during oscillation of the beam
- capture (immobilization) when particle touches the beam's surface

I know, that particles can be introduced and tracked in post-processing. However, my scenario requires a simultaneous simulation of flow and particle flow. Furthermore, the particles should be captured and counted when they hit the beam's surface.

Would it be possible to simulate this scenario with CFX?

Thank you!

Cheers,

Julian

ghorrocks · September 14, 2011, 19:33

Sounds possible. You can define a 0 restitution factor on the beam for the particles so when they hit it they stick. You can count these in post-processing.

Julian K. · September 15, 2011, 16:30

Thanks for the reply.

In the 'Solver Theory Guide', I have seen the 'stick-to-the-wall model'. That would be exactly what I need.

FSI is possible, as well. Thus, CFX seems to be a good choice.

September 14, 2011, 16:38	Transient analysis of particle flow with Fluid-Structure Interaction (FSI)	#1
Julian K. Member Julian Krick Join Date: May 2009 Location: Guelph Posts: 88 Rep Power: 17	Hello! I would like to simulate the following scenario: - flow over an oscillator (beam) -> Fluid-Structure-Interaction (FSI) - particle tracking during oscillation of the beam - capture (immobilization) when particle touches the beam's surface I know, that particles can be introduced and tracked in post-processing. However, my scenario requires a simultaneous simulation of flow and particle flow. Furthermore, the particles should be captured and counted when they hit the beam's surface. Would it be possible to simulate this scenario with CFX? Thank you! Cheers, Julian __________________ grid generation: ICEM CFD 13.0 solver: CFX 13.0

September 15, 2011, 16:30		#3
Julian K. Member Julian Krick Join Date: May 2009 Location: Guelph Posts: 88 Rep Power: 17	Thanks for the reply. In the 'Solver Theory Guide', I have seen the 'stick-to-the-wall model'. That would be exactly what I need. FSI is possible, as well. Thus, CFX seems to be a good choice. __________________ grid generation: ICEM CFD 13.0 solver: CFX 13.0

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 06:21
Fluid Structure Interaction using icoFsiFoam Problems	lr103476	OpenFOAM Running, Solving & CFD	79	August 7, 2014 10:30
Flow meter Design	CD adapco Group Marketing	Siemens	3	June 21, 2011 09:33
Fluid and Structure Interaction	MrAnderson	ANSYS Meshing & Geometry	1	October 8, 2010 17:04
FSI fluid structure interaction tutorial chapter 23	davedave121	CFX	4	February 5, 2010 02:40

September 14, 2011, 19:33		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,854 Rep Power: 144	Sounds possible. You can define a 0 restitution factor on the beam for the particles so when they hit it they stick. You can count these in post-processing.