|
[Sponsors] |
Periodic Interface (Ideal Gas) Massflow Control |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 25, 2011, 12:43 |
Periodic Interface (Ideal Gas) Massflow Control
|
#1 |
Senior Member
Join Date: May 2011
Location: Germany
Posts: 130
Rep Power: 15 |
Hi,
I want to to a translational periodicity and use the material ideal gas. My results using Air at 25° are converging and I can set a specific mass flow at the interface. But I am not allowed to set a mass flow rate at an interface using air ideal gas. If I set it to none, my mass flow is asymptotically going to zero .... almost zero after 50 iteration ...... do I have to set a momentum source? Or whats the solution? Thanks in advance! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
Constant velocity of the material | Sas | CFX | 15 | July 13, 2010 09:56 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 21:09 |