some grid doesn't have value

jiguozhao · May 11, 2011, 20:08

Dear all:
i tried to view one component fraction in POST. but some grids in the surface is not coloured as shown in this picture, they are still gray. I dont know why.
is there anyone who can tell me the reason?
many thanks in advance!
kind regards

Ji Guozhao
g.ji@uq.edu.au

ghorrocks · May 12, 2011, 02:20

You probably defined a plane which is right on a boundary. With numerical error on the mesh location that means 50% of the nodes lie on one side of the boundary and 50% on the other.

The best approach is to use the boundary as your object, not a plane. Otherwise move the plane into the domain by a tiny fraction, just enough to get beyond the numerical noise.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mapping results from CFD grid to structural grid of a free-form surface	mbecker	OpenFOAM Running, Solving & CFD	1	October 18, 2013 11:16
MapFields to New Grid For Extreme Grid Deformations due to Body Motion	albcem	OpenFOAM	0	May 5, 2009 15:17
GRID TO GRID INTERPOLATION in FLUENT	calogero	FLUENT	3	June 4, 2003 09:32
Combustion Convergence problems	Art Stretton	Phoenics	5	April 2, 2002 06:59
Troubles modelling flow through a grid	Hans Klaufus	CFX	1	June 28, 2000 17:43

May 12, 2011, 02:20		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,872 Rep Power: 144	You probably defined a plane which is right on a boundary. With numerical error on the mesh location that means 50% of the nodes lie on one side of the boundary and 50% on the other. The best approach is to use the boundary as your object, not a plane. Otherwise move the plane into the domain by a tiny fraction, just enough to get beyond the numerical noise.