|
[Sponsors] |
![]() |
![]() |
#1 |
Senior Member
Join Date: Jan 2010
Posts: 110
Rep Power: 16 ![]() |
Hi all. I am simulating a density current (water plus sediments) in a rectangular channel and I pretend to see the deposition of the sediments in that channel. I am using the algebraic slip model. In the final section (at downstream) I should have the following behavior: the water should left the domain but the sediments should be "reflected" into the domain. Is this possible to implement in cfx?Any suggestions?
Regards |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Outlet Pressure-flow coupled boundary condition (Windkessel) | cfdfsi | Fluent UDF and Scheme Programming | 3 | July 21, 2017 12:30 |
boundary conditions for simpleFoam calculation | foam_noob | OpenFOAM Running, Solving & CFD | 8 | July 1, 2015 08:07 |
uncertain on model outlet definition | mactech001 | CFX | 0 | February 10, 2010 02:03 |
Boundary condition of free surface model | Tony | FLUENT | 3 | September 27, 2004 13:48 |
UDF for Algebraic Slip Model | Tobias Hirsch | FLUENT | 0 | July 19, 2001 09:19 |