Help in meshing

Echidna · April 13, 2011, 06:25

Hello to everybody.
I have designed a racecar dualplane front wing and i am trying to run it in CFD. I have attached the model inside its boundary in .stp format.
Problem is that i cannot apply any inflation in the model. Could anyone help me and make a correct mesh for this model? Thanks a lot!

Echidna · April 15, 2011, 03:27

Anyone could help?

ghorrocks · April 15, 2011, 07:38

You might have more luck in the meshing forum.

But I doubt it. Meshing is tricky on complex geometries and I doubt many people have hours to spare to help you. You need commercial CFX support, not an internet forum.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing	David-CFD	ANSYS Meshing & Geometry	1	April 1, 2011 06:22
Best Meshing scheme for Cylinder	Nutrex	Main CFD Forum	4	July 29, 2008 12:03
Meshing locks workbench window.	andy2o	CFX	0	February 1, 2008 06:01
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 12:09
Volume Meshing & Face Meshing? singularity of grid	ken	FLUENT	0	September 4, 2003 12:08

April 15, 2011, 03:27		#2
Echidna Member Join Date: Jun 2010 Posts: 77 Rep Power: 16	Anyone could help?

April 15, 2011, 07:38		#3
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,872 Rep Power: 144	You might have more luck in the meshing forum. But I doubt it. Meshing is tricky on complex geometries and I doubt many people have hours to spare to help you. You need commercial CFX support, not an internet forum.