 |
 |
 |
|
|
|
[Sponsors] | ||||
January 3, 2011, 10:04
|
Sato's model of bubble induced turbulence
|
#1 |
|
New Member
Pang
Join Date: Jun 2010
Posts: 9
Rep Power: 16  |
Hi, everyone, happy New Year!
I have a small question about the Sato's model of bubble induced turbulence. I am simulating a two-phase flow with water as liquid continuous phase and air bubbles as dispersed phase with CFX release 12.1. For the bubble induced turbulence I chose the Sato's model. Based on my understanding, since Sato's model is also an eddy-viscosity model and therefore an isotropic model, so for the turbulence models of the liquid phase only the ones based on the eddy-viscosity are appropriated chooses. Am I right?? Any reply or discussions will be highly appreciated!!! Thanks a lot!! Best regards!! Pang |
|
|
|
|
 |
| Tags |
| bubble induced turbulence, sato |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Use of k-epsilon and k-omega Models | Jade M | Main CFD Forum | 40 | January 27, 2023 08:18 |
| Adding a Turbulence Model | doug | OpenFOAM Running, Solving & CFD | 11 | May 21, 2018 14:54 |
| KOmega Turbulence model from wwwopenFOAMWikinet | philippose | OpenFOAM Running, Solving & CFD | 30 | August 4, 2010 11:26 |
| question about turbulence model selection and sensitivity | karananand | Main CFD Forum | 1 | February 26, 2010 05:41 |
| SSG Reynolds Turbulence Model | Georges | CFX | 1 | February 28, 2007 17:15 |
Linear Mode
