Design gas turbine blades with film cooling and cooling Impingement in Ansys 12.0

pedrin84 · August 21, 2010, 17:16

Can help me to draw gas turbine cooled blades in the software ANSYS 12.0 CFX, in the Bladedesign or BladeGen, in WORKBENCH, to simulate in ANSYS CFX 12.0. Somebody have any handbook or manual of Bladedesign or BladeGen 12.0 ?. I appreciate any response. Greetings¡¡¡

Josh · August 24, 2010, 20:49

Hi Pedro -

You should post this in the Geometry section: http://www.cfd-online.com/Forums/ansys-meshing/

pedrin84 · August 25, 2010, 13:22

Thanks you. do you can help me?

Josh · August 25, 2010, 15:07

I'm afraid not. I'm a relatively inexperienced CAD user, but this is a CFD forum. Post your topic on the Geometry forum - you'll have much better luck.

August 21, 2010, 17:16	Design gas turbine blades with film cooling and cooling Impingement in Ansys 12.0	#1
pedrin84 Member pedro gonzalez Join Date: Aug 2010 Location: Barcelona, Venezuela Posts: 35 Rep Power: 16	Can help me to draw gas turbine cooled blades in the software ANSYS 12.0 CFX, in the Bladedesign or BladeGen, in WORKBENCH, to simulate in ANSYS CFX 12.0. Somebody have any handbook or manual of Bladedesign or BladeGen 12.0 ?. I appreciate any response. Greetings¡¡¡

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
modeling cooling holes in turbine blades	rajesh kumar gupta	Main CFD Forum	1	September 9, 2010 13:13
Turbine film cooling simulation	Lorenzo	CFX	1	September 9, 2010 13:13
internal cooling of gas turbine blade	vinay	FLUENT	0	October 20, 2008 16:20
gas turbine combustor linear cooling holes- cfd	P.K.UDAYAKUMAR	FLUENT	1	December 13, 2002 03:08
Info: Short Course On Thermal Design of Electronic Equipment	Arnold Free	Main CFD Forum	0	August 10, 1999 11:18

August 24, 2010, 20:49		#2
Josh Senior Member Joshua Counsil Join Date: Jul 2009 Location: Halifax, Nova Scotia, Canada Posts: 366 Rep Power: 18	Hi Pedro - You should post this in the Geometry section: http://www.cfd-online.com/Forums/ansys-meshing/

August 25, 2010, 13:22		#3
pedrin84 Member pedro gonzalez Join Date: Aug 2010 Location: Barcelona, Venezuela Posts: 35 Rep Power: 16	Thanks you. do you can help me?

August 25, 2010, 15:07		#4
Josh Senior Member Joshua Counsil Join Date: Jul 2009 Location: Halifax, Nova Scotia, Canada Posts: 366 Rep Power: 18	I'm afraid not. I'm a relatively inexperienced CAD user, but this is a CFD forum. Post your topic on the Geometry forum - you'll have much better luck.