use k-epsilon model for solidification -- CFD Online Discussion Forums

July 6, 2010, 06:49	use k-epsilon model for solidification	#1
4mr1 New Member CFX beginner Join Date: Jul 2010 Posts: 1 Rep Power: 0	HI all, I am new to CFX. I try to model solidification of PCM spheres using CFX. can i use k-epsilon model? i want to know the heat absorbed by the PCM. I tried using laminar, sst, and so far standard k-e converged faster even with big time steps. But i am not sure it is correct or not. PCM = phase change material PCM spheres = PCM encapsulated by hard case (hollow sphere) Please advise... thanks. Last edited by 4mr1; July 6, 2010 at 09:17.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Centrifugal Pump and Turbulence Model	Michiel	CFX	12	January 25, 2010 04:20
k and epsilon discretization of RNG model	mehran	Fidelity CFD	0	January 24, 2009 01:01
SimpleFoam k and epsilon bounded	nedved	OpenFOAM Running, Solving & CFD	1	November 25, 2008 21:21
simulation results for k-w model and SST model	Li	CFX	7	June 29, 2007 05:19
K-Epsilon Model	sangit	Main CFD Forum	2	September 9, 2004 14:19

All times are GMT -4. The time now is 16:16.