Problem with Automatic Default Interfaces

jehan · June 15, 2010, 05:54

Hi there,
I have a problem with the Automatic Default Interfaces,
the box is switched on (along with the Automatic Defaults Domain) in the case options, but when I 'm setting the differents domains , no interface is generated : /

I m using CFX 12.1 in stand alone mode (same problem with the workbench).

Might someone know where the problem comes from ? Thanks.

jehan · June 15, 2010, 11:11

Sorry,
it appears I have been given a mis-meshed file,
I only have the problem with one specific mesh .

Next time I'll think twice before asking for help

June 15, 2010, 05:54	Problem with Automatic Default Interfaces	#1
jehan New Member julien Join Date: Jun 2010 Posts: 6 Rep Power: 16	Hi there, I have a problem with the Automatic Default Interfaces, the box is switched on (along with the Automatic Defaults Domain) in the case options, but when I 'm setting the differents domains , no interface is generated : / I m using CFX 12.1 in stand alone mode (same problem with the workbench). Might someone know where the problem comes from ? Thanks.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem in fvschemes divSchemes cannot use Gauss linearUpwind	nico765	OpenFOAM Bugs	30	August 9, 2018 08:39
laplacian1%7cAUp is undefined in dictionary problem with icoFoam	derath	OpenFOAM Pre-Processing	3	June 14, 2013 07:24
increasing mesh quality is leading to poor convergence	tippo	CFX	2	May 5, 2009 11:55
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 16:55
Periodic flow boundary condition problem	sudha	FLUENT	3	April 28, 2004 09:40

June 15, 2010, 11:11		#2
jehan New Member julien Join Date: Jun 2010 Posts: 6 Rep Power: 16	Sorry, it appears I have been given a mis-meshed file, I only have the problem with one specific mesh . Next time I'll think twice before asking for help