|
[Sponsors] |
April 26, 2010, 11:36 |
CFX_Pre Qutput frequency
|
#1 |
New Member
Abhishek
Join Date: Mar 2010
Posts: 7
Rep Power: 16 |
Hi There,
I am trying to save a specific set of trns. For eg: if there are 1 to 100 iterations (timesteps) done on a simulation and i was to save the trns from 50 to 75 is there a way in CFX to give this directly rather than type 50, 51, 52...and so on till 75 for timestep list. Also, these timesteps correspond to a say a specifc time in the simulation eg say between 1s and 3 seconds capture the iteration between 50-75, how would i go about recording the timelist rather than specifying every single item like in the previous case Pls help me out on this Cheers Chirath |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Will a multi-grid method damp out the high frequency physical wave? | hadesmajesty | Main CFD Forum | 8 | October 13, 2009 00:26 |
MFX - Frequency resonance | Sandman | CFX | 2 | October 26, 2007 17:30 |
Backward FAcing Step - Frequency | CFDtoy | Main CFD Forum | 8 | October 29, 2006 20:51 |
Reasons for failed validation at high frequency | zonexo | Main CFD Forum | 5 | October 23, 2006 09:32 |
time and frequency domain | Tom Brown | Main CFD Forum | 3 | February 11, 2002 16:51 |