Transient Simulation: Initial Time -- CFD Online Discussion Forums

April 18, 2010, 09:19	Transient Simulation: Initial Time	#1
blackbody Member Join Date: Feb 2010 Posts: 33 Rep Power: 16	Hi everyone! Quick question: I want to simulate a transient rotor/stator behaviour: first i created the frozen rotor solution. than I specified some monitor points to check if the result gets "periodic, steady" over time and therefore has converged. this has used about 400 timesteps. in this time, the rotor has rotated over 4.5 pitches. now i want to run the transient simulation with an output of transient results (for each time step). can i specify the initial time to 0s (rotor is at beginning place) and use the old result i got as an initial value? will the convergence be still there??? thank you!

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SimpleFoam k and epsilon bounded	nedved	OpenFOAM Running, Solving & CFD	16	March 4, 2017 09:30
convergence problem when use pisoFoam, LES for wind tunnel case	Forrest_Lei	OpenFOAM	3	July 19, 2011 07:00
Error log	vw.cfd	OpenFOAM	6	August 7, 2009 06:44
Differences between serial and parallel runs	carsten	OpenFOAM Bugs	11	September 12, 2008 12:16
Convergence moving mesh	lr103476	OpenFOAM Running, Solving & CFD	30	November 19, 2007 15:09

All times are GMT -4. The time now is 04:17.