Get coordinates of specific points

blackbody · March 18, 2010, 03:42

Hello
Where can I get the coordinates of specific points? I have only a mesh (no geometry). I tryed the function calculator in CFD-Post but I want for example the y coordinate at maxVal of z. Function calculator doesnt provide this, right?
Is there any way I can easily get coordinates of points I want (eg. leading edge at midspan, midspan of inlet,....)
Where is this been done: in CFX pre, post, ICEM,... ?
Thank you very much!

Amit Roghs · March 19, 2010, 09:09

You should try opening the mesh file in Icem CFD, then run the Tcl/Tk script option.
After that creat points on the locations where you interested in finding co-ordinates.
Save the script and open it in note pad.
You will have the co-ordinates along with the commands used.
You can use the value of co-ordinates from this file.

March 18, 2010, 03:42	Get coordinates of specific points	#1
blackbody Member Join Date: Feb 2010 Posts: 33 Rep Power: 16	Hello Where can I get the coordinates of specific points? I have only a mesh (no geometry). I tryed the function calculator in CFD-Post but I want for example the y coordinate at maxVal of z. Function calculator doesnt provide this, right? Is there any way I can easily get coordinates of points I want (eg. leading edge at midspan, midspan of inlet,....) Where is this been done: in CFX pre, post, ICEM,... ? Thank you very much!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 06:21
Simulation of a single bubble with a VOF-method	Suzzn	CFX	21	January 29, 2018 01:58
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 08:36
Two-Phase Buoyant Flow Issue	Miguel Baritto	CFX	4	August 31, 2006 13:02
How to get flow variables at specific coordinates?	circle2000	FLUENT	2	July 20, 2004 23:55

March 19, 2010, 09:09		#2
Amit Roghs New Member Amit Roghelia Join Date: Apr 2009 Posts: 4 Rep Power: 17	You should try opening the mesh file in Icem CFD, then run the Tcl/Tk script option. After that creat points on the locations where you interested in finding co-ordinates. Save the script and open it in note pad. You will have the co-ordinates along with the commands used. You can use the value of co-ordinates from this file.