 |
 |
 |
|
|
|
[Sponsors] | ||||
October 26, 2009, 06:32
|
convegence problem with high angle of attack
|
#1 |
|
New Member
Join Date: Mar 2009
Posts: 24
Rep Power: 17  |
I am running transitional simulation in CFX12 with a high angle of attack. The similar simulation under the same operating conditions but with 0 deg angle of attack has also been done and a converged results was obtained (001.res). then I use this 001.res as initial data to start running high angle of attack case, but no convergence at all no matter what I have tried. why is it? Could you please give me some ideas on it? how to obtain converged result for the high incidence angle case?
many thanks, littlelz |
|
|
|
|
|
October 27, 2009, 16:42
|
|
#2 |
|
Senior Member
Join Date: Apr 2009
Posts: 531
Rep Power: 21 |
I would guess it's transient. Try running transient for a while and see if this converges.
|
|
|
|
|
|
|
October 28, 2009, 07:07
|
|
#3 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,871
Rep Power: 144 |
||
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| angle of attack CFX | Arj | CFX | 17 | October 2, 2015 08:07 |
| introducing angle of attack on ICEMCFD HEXA | icem beginner | Main CFD Forum | 3 | December 17, 2008 06:05 |
| introducing angle of attack on ICEMCFD HEXA | icem beginner | FLUENT | 2 | December 6, 2008 16:34 |
| Problem with Convergence at high flow rates | Syed | Siemens | 1 | April 10, 2007 16:18 |
| Lift Coefficien Vs. Angle of Attack | cfd_pro | FLUENT | 0 | August 23, 2002 17:16 |
Linear Mode
