ERROR #001100279 All nodes in the domain named XYZ are on interfaces.

peterputer1 · October 7, 2009, 09:53

Hej,

i ve got a problem while trying to run my simulation. In Pre everything looks nice and i dont get any error msg there. If i start the simulation i get the following error msg:

| ERROR #001100279 has occurred in subroutine ErrAction. |
| Message: |
| All nodes in the domain named XYZ are on interfaces. Please |
| modify the mesh to include some non-interface (e.g. internal) no- |
| des.

Honestly i dont get what the problem should be. I ve already done simulations with parts just defined as interfaces, this should not be a problem for the solver right?
So if anybody has some hints, would be great.

Regards

ghorrocks · October 7, 2009, 18:29

The error message says exactly what the problem is. You have a domain which has no internal nodes. All nodes are on interfaces and this is not allowable. You need to remesh and put some nodes inside the domain.

peterputer1 · October 8, 2009, 08:56

Hej,

i just started it with Solver Version 12 instead of 11 and it is running without any problem...But one of my last calculation was with some domains just with interfaces as well, but run in 11 as i remember correctly. Anyway calculation started

Regards

October 7, 2009, 09:53	ERROR #001100279 All nodes in the domain named XYZ are on interfaces.	#1
peterputer1 New Member Join Date: Sep 2009 Posts: 9 Rep Power: 17	Hej, i ve got a problem while trying to run my simulation. In Pre everything looks nice and i dont get any error msg there. If i start the simulation i get the following error msg: \| ERROR #001100279 has occurred in subroutine ErrAction. \| \| Message: \| \| All nodes in the domain named XYZ are on interfaces. Please \| \| modify the mesh to include some non-interface (e.g. internal) no- \| \| des. Honestly i dont get what the problem should be. I ve already done simulations with parts just defined as interfaces, this should not be a problem for the solver right? So if anybody has some hints, would be great. Regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM] Native ParaView Reader Bugs	tj22	ParaView	270	January 4, 2016 12:39
Multiple domain interfaces on a single surface	mike	CFX	2	January 26, 2009 18:03
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 21:50
CFX Solver Memory Error	mike	CFX	1	March 19, 2008 08:22
CFX4.3 -build analysis form	Chie Min	CFX	5	July 13, 2001 00:19

October 7, 2009, 18:29		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,872 Rep Power: 144	The error message says exactly what the problem is. You have a domain which has no internal nodes. All nodes are on interfaces and this is not allowable. You need to remesh and put some nodes inside the domain.

October 8, 2009, 08:56		#3
peterputer1 New Member Join Date: Sep 2009 Posts: 9 Rep Power: 17	Hej, i just started it with Solver Version 12 instead of 11 and it is running without any problem...But one of my last calculation was with some domains just with interfaces as well, but run in 11 as i remember correctly. Anyway calculation started Regards