ERROR #001100279 NAME_MOD: Error finding variable "PRES"

peterputer1 · September 21, 2009, 09:50

Hej,

if I run my definition file i get the following error msg in the solver.

| ERROR #001100279 has occurred in subroutine ErrAction. |
| Message: |
| NAME_MOD: Error finding variable "PRES"

In my simulation i defined a new material, after adding it to the domain i get the error msg, without the computation runs.
I set a new solid, and took an expression for density, specific heat and conductivity.
I defined them in a csv table and just wrote in "Material properties"

Material.Density(T,p) as an expression.

I m not sure if i did it correctly, so hopefully you can help me

Regards

ghorrocks · September 21, 2009, 19:32

I don't think you can have a solid density a function of pressure. The pressure variable does not exist in solid regions. Or is the solid for particle tracking?

peterputer1 · September 22, 2009, 06:20

Hej,
thanks for the answer. My bad, for sure i cant set a pressure value for a solid :/
Thx a lot
Regards

September 21, 2009, 09:50	ERROR #001100279 NAME_MOD: Error finding variable "PRES"	#1
peterputer1 New Member Join Date: Sep 2009 Posts: 9 Rep Power: 17	Hej, if I run my definition file i get the following error msg in the solver. \| ERROR #001100279 has occurred in subroutine ErrAction. \| \| Message: \| \| NAME_MOD: Error finding variable "PRES" In my simulation i defined a new material, after adding it to the domain i get the error msg, without the computation runs. I set a new solid, and took an expression for density, specific heat and conductivity. I defined them in a csv table and just wrote in "Material properties" Material.Density(T,p) as an expression. I m not sure if i did it correctly, so hopefully you can help me Regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Instalation on ubuntu 710	basilwatson	OpenFOAM Installation	17	March 16, 2012 21:16
error in COMSOL:'ERROR:6164 Duplicate Variable'	bhushas	COMSOL	1	May 30, 2008 05:35
Problems with additional variable	Krishna Premi	CFX	1	October 29, 2007 09:19
Env variable not set	gruber2	OpenFOAM Installation	5	December 30, 2005 05:27
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 21:09

September 21, 2009, 19:32		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,872 Rep Power: 144	I don't think you can have a solid density a function of pressure. The pressure variable does not exist in solid regions. Or is the solid for particle tracking?

September 22, 2009, 06:20		#3
peterputer1 New Member Join Date: Sep 2009 Posts: 9 Rep Power: 17	Hej, thanks for the answer. My bad, for sure i cant set a pressure value for a solid :/ Thx a lot Regards