Heat transfer

csmistry · August 20, 2009, 09:35

I am doing heat transfer analysis inside the tube. i modeled cylindrical domain and analys the problem then i though of inserting plate (insert) in tube to enhance heat transfer so i modeled tube with insert in three ways... 1. cut the portion from tube2. frozen the strip and 3. freedge the strip but non of that is giving me idea to define region...lioke inlet,outlet,outerwall,strip but while solving problem it gives error of more parameter and not permitting me to solve... how to move ahead...

ghorrocks · August 20, 2009, 19:39

Post the output file.

This sounds like a straight forward simulation. Have you done the tutorial examples? Tutorial 16 (the heating coil one) should be relevant to what you are doing.

August 20, 2009, 09:35	Heat transfer	#1
csmistry Member mistry Join Date: Apr 2009 Location: India Posts: 69 Rep Power: 17	I am doing heat transfer analysis inside the tube. i modeled cylindrical domain and analys the problem then i though of inserting plate (insert) in tube to enhance heat transfer so i modeled tube with insert in three ways... 1. cut the portion from tube2. frozen the strip and 3. freedge the strip but non of that is giving me idea to define region...lioke inlet,outlet,outerwall,strip but while solving problem it gives error of more parameter and not permitting me to solve... how to move ahead...

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Heat transfer coefficient - what is waht	Stan	FLUENT	28	December 29, 2021 17:29
How can I increase Heat Transfer at Domain Interf?	B.Simon	CFX	3	October 28, 2008 19:53
CFX Heat Transfer	RJamison	CFX	0	July 24, 2008 13:11
Question on heat transfer coefficient!!!	Benny	FLUENT	7	June 7, 2005 10:25
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 16:55

August 20, 2009, 19:39		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,870 Rep Power: 144	Post the output file. This sounds like a straight forward simulation. Have you done the tutorial examples? Tutorial 16 (the heating coil one) should be relevant to what you are doing.